hakkında şirket haberleri Yem torbası paketleme makinesinin genel hataları ve tedavi önlemleri

The bag-type packaging machine for pharmaceutical enterprises to achieve packaging automation, operators only need to put a few hundred bags in the equipment bag, equipment mechanical grasp will automatically take the bag, print the date, open the bag, to the metering device signal measurement and blanking, sealing, output.
It is reported that the customer can also according to the packaging needs to add the door emergency stop, automatic card, abnormal discharge and other details of the function, the whole process of packaging without manual work, effectively improve the production efficiency, for the enterprise to save labor costs and management costs, greatly reduce the cost.
In addition, to the bag packaging machine can also achieve a multi-purpose, users only need to support different materials according to different metering devices, can achieve the full automatic packaging of particles, powder, block, liquid, and other products.
At present, with the rapid development of automation and intelligent technology, the automatic bag type vacuum packaging machine came into being, this type of packaging machine by the metering machine and bag type vacuum packaging machine mainframe two parts.Through intelligence, mechanization to complete the work, can achieve unmanned workshop management, by the industry's extensive attention and favor.
Although the advantages of full automatic bag vacuum packaging machine are outstanding, reasonable operation can bring many benefits to the enterprise, but in the actual operation process, through many users, the equipment often appear some faults.
Fault i. the membrane material is easily shifted and cannot be fed normally when the equipment is working.How do you adjust in this situation?Some factory technicians said that in the equipment such as encountered membrane material deviation, by adjusting the position of the film and the tension balance bar are invalid, can be adjusted by adjusting the Angle of the triangular plate to solve the problem.
In addition, if the upper membrane material deviates from the clamping chain, the triangular plate can be adjusted clockwise;If the lower film material deviates from the clamping chain, the upper triangular plate can be adjusted counterclockwise.
Fault two, the temperature of the shrinkage machine is slow or unable to rise to a higher temperature.What are the reasons for this?It is reported that the heater line is the main power line through a magnetic switch and then to the electrical heat pipe, so in the case of slow or unable to rise to a higher temperature, should first detect the magnetic switch contacts are normal.
Generally speaking, if the line does not pass one of the phases, the above phenomenon will occur;If the magnetic switch is normal, the meter can be checked again to see if the ohm value of each phase is the same with the machine;If all phases are connected but the line or electric heat pipe is still abnormal, the heater needs to be replaced.
Three, the product packaging vacuum is low.The vacuum degree of the product mainly depends on the vacuum pump, when this kind of problem occurs, the user should check whether the vacuum pump oil is contaminated, if contaminated, the need to replace the vacuum pump oil.
Fault four, sealing uneven or not sealing.The reason for the failure is related to whether the heating time is adjusted well and whether there are impurities on the heating isolation cloth.The user needs to adjust the heating time and temperature. If there are attachments on the heating isolation cloth, it should be cleaned and replaced in time to prevent the normal work from being affected.